SAFETY WARNING:
Installation work of this unit must be done by a professional, a
licensed electrician or an electric engineer.
Never install this unit during a thunder storm.
Switch off the power before you start installation work.
This unit is for indoor use only.
This unit is not intended for use in or around wet or potentially
wet areas including, but not limited to, aquariums, saunas, showers
and fountains.
Risk of Electric Shock!
INSTALLATION GUIDE:
Before installation, you may need to get a IEC C13 Outlet. Decide
your wire gauge, and ask store attendant for assistance what color
of connectors you should get) from your local hardware or electric
supply or home improvement stores.
Minimum tools required: A fine to medium fine philips screw driver,
and a pair of scissors, and a pair of mid size slip joint pliers
1. Turn off electricity in the house
2. Decide where to place this unit
3. Choose the side you want the cord exit to choose IEC C14 Built
in power strips
4. Match the color of the wires and secure the wire connection with
proper wire connectors built in IEC C13 plug.(different wire gauge use different colored wire connectors)
- Mount the power strip where you want it to be:
A) For power strips with mounting tabs on both ends: screw down the
unit on the floor, wall or in your cabinet or on your rack, where
you want it to be
B) For power strips without mounting tabs, but to be mounted with
clips, place the unit where you want it to be first, make marks
where to install the clips, which normally should be placed about
min 2”<power strips length away from each end, and then screw
the clips down with screws provided. Then, snap the power strip in
on the clips - Push IEC C13 outlet plug into IEC C13 inlet power strips , and push
switch to ON. Turn electricity back on, you are ready to go.
Note:
We warmly welcome all customers to do OEM and ODM production.
